Short Name: AutoPreallocate
Requires: VI Scripting
Class: VI Properties
To Use: Create a property.
Get or set the Autopreallocate arrays and strings setting on VIs. This is used by the FPGA module to optimize array and string operations by forcing LabVIEW to preallocate memory at compile time rather than dynamically allocating memory at run time.
This property is similar to the Autopreallocate arrays and strings checkbox on the Execution Page of the VI Properties dialog box.
The following table lists the characteristics of this property.
| Data type | |
| Permissions | Read/Write |
| Available in Run-Time Engine | Yes |
| Available in Real-Time Operating System | Yes |
| Settable when the VI is running | No |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access allowed | No |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |