Short Name: Active Plot
Requires: Full Development System
Class: 3D Mesh Plot Properties
Gets or sets the active plot. After you get or set the active plot, you then can set properties or invoke methods that affect only the specified plot.
You can use the Plot properties to set the active plot.
This property is similar to the Plot List option on the Mesh page of the 3D Plot Properties dialog box.
The following table lists the characteristics of this property.
| Available in Run-Time Engine and Real-Time Operating System | Yes |
| Permissions | Read/Write |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | Yes |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access allowed | Yes |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |