Build Waveform (Analog Waveform) Function

Owning Palette: Analog Waveform VIs and Functions

Requires: Base Development System

Builds an analog waveform or modifies an existing waveform. If you do not wire the waveform input, the function creates a new waveform based on the components you wire. If you wire the waveform input, the function modifies the waveform based on the components you wire.

Examples

waveform is the analog waveform you want to edit. If you do not wire an existing waveform, the function creates a new waveform based on the components you wire.
t0 specifies the start time of the waveform.
dt specifies the time interval in seconds between data points in the waveform.
Y specifies the data values of the waveform.
t0 specifies the start time of the waveform.
dt specifies the time interval in seconds between data points in the waveform.
Y specifies the data values of the waveform.
attributes sets the names and values of all waveform attributes. You also can use the Set Waveform Attribute function to set the name and value of a single attribute.
waveform is the resulting waveform. If you did not wire an existing waveform, this is a new waveform. If you wired an existing waveform, this is the edited waveform.

Examples

Refer to the following VIs for examples of using the Build Waveform (Analog Waveform) function: