Short Name: Alarming.Hi.Level
Requires: Base Development System
Class: Variable Properties
To Use: Create a property.
Gets or sets the value, in engineering units, that evokes the HI alarm condition for a shared variable. To use this property, you must install the LabVIEW Datalogging and Supervisory Control Module.
The shared variable remains in the alarm state until the shared variable value goes below this value minus the deadband value.
| Note You can enable alarming only for network-published shared variables. |
This property is similar to the Level/Change option on the Alarming page of the Shared Variable Properties dialog box.
The following table lists the characteristics of this property.
| Data type |  |
| Permissions | Read/Write |
| Available in Run-Time Engine | No |
| Available in Real-Time Operating System | No |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access allowed | Yes |