Short Name: Alarming.Hi.Area
Requires: Base Development System
Class: Variable Properties
To Use: Create a property.
Gets or sets a descriptive area name for the HI alarm for a shared variable. To use this property, you must install the LabVIEW Datalogging and Supervisory Control Module.
Create alarm areas to acknowledge an entire area of alarms as a single batch operation.
| Note You can enable alarming only for network-published shared variables. |
This property is similar to the Area option on the Alarming page of the Shared Variable Properties dialog box.
The following table lists the characteristics of this property.
| Data type |  |
| Permissions | Read/Write |
| Available in Run-Time Engine | No |
| Available in Real-Time Operating System | No |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access allowed | Yes |