Short Name: RT.DatapointsInWaveform
Requires: Base Development System
Class: Variable Properties
To Use: Create a property.
Gets or sets the number of data points for a shared variable with a Data Type of Waveform. You can only use this property in the LabVIEW development system, but you must install the LabVIEW Real-Time Module to make this property available.
An error occurs if you attempt to set this property when the VI is running.
The following table lists the characteristics of this property.
| Data type | |
| Permissions | Read/Write |
| Available in Run-Time Engine | No |
| Available in Real-Time Operating System | No |
| Settable when the VI is running | No |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access allowed | Yes |