Digital Transition Location Property

Short Name: TransitionLocation

Requires: Base Development System

Class: Bus Properties

To Use: Create a property.

Sets whether to display high to low transitions at the previous point, in between points, or at the new point on the x-axis. The default displays high to low transitions at the new point on the x-axis. Applies to digital plots only.

This property is similar to the Transition Location item on the shortcut menu of a plot.

Remarks

The following table lists the characteristics of this property.

Data type
PermissionsRead/Write
Available in Run-Time EngineYes
Available in Real-Time Operating SystemYes
Settable when the VI is runningYes
Loads the front panel into memoryNo
Need to authenticate before useNo
Loads the block diagram into memoryNo
Remote access allowedYes