Short Name: Quiver Mode
Requires: Full Development System
Class: 3D Quiver Plot Properties
Sets the display mode of the quiver.
Select from With and Without Surface.
This property is similar to the Quiver mode option on the Quiver page of the 3D Plot Properties dialog box.
The following table lists the characteristics of this property.
| Available in Run-Time Engine and Real-Time Operating System | Yes |
| Permissions | Read/Write |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | Yes |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access allowed | Yes |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |