Short Name: Plot Opacity
Requires: Full Development System
Class: 3D Quiver Plot Properties
Specifies the level of opacity of the color you apply to the plot.
Opacity ranges from 0 to 100, where 100 is completely opaque.
This property is similar to the Plot opacity(%) option on the Quiver page of the 3D Plot Properties dialog box.
The following table lists the characteristics of this property.
| Available in Run-Time Engine and Real-Time Operating System | Yes |
| Permissions | Read/Write |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | Yes |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access allowed | Yes |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |