Short Name: Slice Offset
Requires: Full Development System
Class: 3D Pie Plot Properties
Moves the center of the pie a few slices out.
This property is similar to the Show offset option on the Pie page of the 3D Plot Properties dialog box.
The following table lists the characteristics of this property.
| Available in Run-Time Engine and Real-Time Operating System | Yes |
| Permissions | Read/Write |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | Yes |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access allowed | Yes |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |