Short Name: Error Bar Interpolation
Requires: Base Development System
Class: 2D Error Bar Plot Properties
Specifies the interpolation of the plot.
Choose from one of the following values: 0 (show input data as points), 1 (show input data as lines), and 2 (show input data as bars).
This property is similar to the Plot Interpolation option on the Plots page of the Properties dialog box.
The following table lists the characteristics of this property.
| Available in Run-Time Engine and Real-Time Operating System | Yes |
| Permissions | Read/Write |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | Yes |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access allowed | Yes |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |