GPIB Trigger Function

Owning Palette: GPIB Functions

Requires: Base Development System

Sends GET (Group Execute Trigger) to the device indicated by address string.

Add to the block diagram

Find on the palette

	address string contains the address of the GPIB device with which the function communicates. You can input both the primary and secondary addresses in address string by using the form primary+secondary. Both primary and secondary are decimal values, so if primary is 2 and secondary is 3, address string is 2+3. If you do not specify an address, the functions do not perform addressing before they attempt to read and write the string. They assume you have either sent these commands another way or that another controller is in charge and therefore responsible for the addressing. If the controller is supposed to address the device but does not do so before the time limit expires, the functions terminate with GPIB error 6 (timeout) and set bit 14 in status. If the GPIB is not the Controller-In-Charge, do not specify address string. When there are multiple GPIB controllers that LabVIEW can use, a prefix to address string in the form ID:address (or ID: if no address is necessary) determines the controller that a specific function uses. For example, to set GPIB controller 2 to talk to a device on address 3, use the prefix 2:3. If a controller ID is not present, the function defaults to controller (or bus) number 0.
	error in describes error conditions that occur before this node runs. This input provides standard error in functionality.
	status is a Boolean array in which each bit describes a state of the GPIB Controller. If an error occurs, the function sets bit 15. GPIB error is valid only if bit 15 of status is set. The following table shows the numeric value and symbolic status of each bit in status. This table also includes a description of each bit. Status Bit Numeric Value Symbolic Status Description 0 1 DCAS Device Clear state 1 2 DTAS Device Trigger State 2 4 LACS Listener Active 3 8 TACS Talker Active 4 16 ATN Attention Asserted 5 32 CIC Controller-In-Charge 6 64 REM Remote State 7 128 LOK Lockout State 8 256 CMPL Operation Completed 12 4096 SRQI SRQ Detected while CIC 13 8192 END EOI or EOS Detected 14 16384 TIMO Timeout 15 -32768 ERR Error Detected
	error out contains error information. This output provides standard error out functionality.